I could not pull it out with my hands after tapping it in. But to be clear, there’s only a sheer force to deal with, and it’s light.

I cut a bicycle axle bolt in half, and embedded it in the brick so there is a bicycle sprocket on the wall. Then a chain wraps another sprocket, which turns a shaft that goes all the way though the wall to the other side, where it connects to a right-angle gearbox, which attaches to a water valve. It’s lightweight overall… just the weight of a sprocket, chain, and a small decorative wood thing out of wood to serve as a handle.

This might come a bit too late but why didn’t you just get threaded rod and use one of these instead?

I did not know anchors like that existed for machine bolts. That’s good to know! However, it would not have helped in this situation. The bicycle axle has non-standard threading (~9mm bolt with a thread pitch that’s 2 steps away from the norm). Since it had a special nut that interfaced to ball bearings, I could not bring in a standard bolt or threaded rod. And the threaded portion of the axle was short enough that no threads could have gone into the wall. I could have added threads to the bare portion, but my die set skips the ø=9mm size.

I was asking more for future reference – whether or not I should ever repeat this. And I think you answered that. Even if I get lucky in the future on getting a perfect fit at that moment, temp changes could blow it. I guess I’ll assume anchors (chemical and mechanical) are designed to handle the temp changes.

emphasis mine:

Anti-nuclear is like anti-GMO and anti-vax: pure ignorance, and fear of that which they don’t understand.

First of all anti- #GMO stances are often derived from anti-Bayer-Monsanto stances. There is no transparency about whether Monsanto is in the supply chain of any given thing you buy, so boycotting GMO is as accurate as ethical consumers can get to boycotting Monsanto. It would either require pure ignorance or distaste for humanity to support that company with its pernicious history and intent to eventually take control over the world’s food supply.

Then there’s the anti-GMO-tech camp (which is what you had in mind). You have people who are anti-all-GMO and those who are anti-risky-GMO. It’s pure technological ignorance to regard all GMO equally safe or equally unsafe. GMO is an umbrella of many techniques. Some of those techniques are as low risk as cross-breeding in ways that can happens in nature. Other invasive techniques are extremely risky & experimental. You’re wiser if you separate the different GMO techniques and accept the low risk ones while condemning the foolishly risky approaches at the hands of a profit-driven corporation taking every shortcut they can get away with.

So in short:

• Boycott all U.S.-sourced GMO if you’re an ethical consumer. (note the EU produces GMO without Monsanto)
• Boycott just high-risk GMO techniques if you’re unethical but at least wise about the risks. (note this is somewhat impractical because you don’t have the transparency of knowing what technique was used)
• Boycott no GMO at all if you’re ignorant about risks & simultaneously unethical.