Wow yeah that first one is pretty terrible looking 😅

I’m decently pleased with mine though, but I’m really looking forward to the quality on the voron. I actually already have “the filter” on my current printer (slightly oddly placed in the tent, but it works), and I just connected it directly to the printer PSU and manually turn it on/off with a toggle switch.

The solution was more cooling. It was warping due to too much heat, I increased cooling to 100% and reduced overhang speed slightly and it now prints well.

Both ASA and ABS are approved materials. ASA has higher heat defection than ABS, should be easier to print and it smells significantly less when printing.

Fans are completely disabled, except for overhangs and bridges. If I disable fans for overhangs and bridges, they sag like crazy.

I doubt draft shield is going to do anything, the printer is already completely enclosed in a tent. I have around 50-55°C inside the tent.

Edit: I tried a re-print with less cooling for overhangs, it seems to exacerbate the issue significantly.

I just swipe left for “back” (android), and I can access everything just fine, it just closes the TOS. Just do that every time I open the app, works like a charm.

But then you don’t want face-melting lasers.

Now hold on…I can see that being useful too. Two consecutive failed face IDs? BAM!!!* face melting laser on the (probably) unauthorized person trying to access your phone.

Because the implication is, that Tesla isn’t doing something bad WRT how they designed the stalls? IDK, anything that’s not bashing Tesla directly seems to get down voted here, even if it’s not actually related specifically to Tesla.

It is objectively safer to park like that (charging or not). Most parking lot accidents happens as someone leaves the parking spot. The risk of accidents when leaving the parking spot is significantly reduced compared to parking front first.

It was actually quite well planned out, opening up the network in stages to see that everything worked as intended before a wide rollout. You can even see in the app which chargers are open to other car brands. This mistake is 100% on the driver, the info is easily available to that person.

On top of that, the bZ4x is apparently a really shitty car. So on top of only having that one model, it’s also a terrible one.

Would this be a good entry level device?

Kind of impossible to say right now, it’s not released yet. On paper it seems like a good deal, almost too good at that price point. I wouldn’t buy one until I’ve seen some reviews.

Damn, that’s a crazy low price for a coreXY with a 42.000cm^3 build volume

My dad is pretty unhappy with his Mercedes EQS which costs significantly more than the model S, it also had issues with loose interior trim and panel gaps. And despite the fairly high price point its still riddled with shitty plastic interior. It kind of feels like all manufacturers are rushing stuff out the door at the cost of QC.

I’m not sure how high the resolution is on resin printers, but the tip of a record stylus is maximum 0.001mm in diameter, here are the specs for records, it’s some pretty small grooves with very fine detail you need for something that’s passable.

That image is not mine, it’s just for reference by the other user to show me where to look

Nothing, and it just reports 100% packet loss when I terminate the ping command.

as far as i can tell from the output, i think my DNS is working?

this is the contents of the interfaces file

I don’t have anythiung seperated in to different VLANs, and i only use this single subnet. all other devices can ping outbound without issues.

no