I’ve banged on about this at length before. I prefer woodworking in inches because I have to divide by 3 and 4 a lot more often than divide by 5. It turns out that the fractional inch system evolved alongside woodworking for a very long time and it solves a lot of the problems woodworkers actually face…as long as you’re not a European scraping in the dirt for something to feel superior about.
I do woodworking a bit too, but I normally just do the slanty ruler/tape trick to divide any straight parallel face into n equal lengths.
I hate all forms of mental arithmetic; I also avoid measuring as much as possible too. Maybe that’s why everything i make is so shit.
I guess if you’re mass producing things you can’t just manually mark off each and every part though - but even then I’d probably want to work to a template rather than to measure.
I’ve banged on about this at length before. I prefer woodworking in inches because I have to divide by 3 and 4 a lot more often than divide by 5. It turns out that the fractional inch system evolved alongside woodworking for a very long time and it solves a lot of the problems woodworkers actually face…as long as you’re not a European scraping in the dirt for something to feel superior about.
I do woodworking a bit too, but I normally just do the slanty ruler/tape trick to divide any straight parallel face into n equal lengths. I hate all forms of mental arithmetic; I also avoid measuring as much as possible too. Maybe that’s why everything i make is so shit.
I guess if you’re mass producing things you can’t just manually mark off each and every part though - but even then I’d probably want to work to a template rather than to measure.